Groupe SEB USA T FAL Hot Beverage Maker BR 301 User Manual

F
GB  
D
QUICK & HOT  
NL  
I
DK  
S
N
FIN  
 
fig.1a  
fig.1b  
fig.2  
fig.3  
fig.4  
1
2
fig.5  
fig.6  
fig.7  
2
1
fig.8  
fig.9  
 
Thank you for purchasing this Quick and Hot water urn. Please read the instructions common to all of  
our models carefully and keep them in a safe place.  
GB  
PRODUCT DESCRIPTION (fig. 1)  
A water tank  
B tank lid  
G automatic mug button for pre-setting  
quantity  
C water release valve  
D body of the appliance  
E nozzle or water outlet  
H manual “continuous water supply” button  
I
J
water volume selector (according to model)  
filter cartridge (according to model)  
K ON/OFF and filter cartridge change light  
(according to model)  
RINSING BEFORE USING FOR THE FIRST TIME  
Remove all of the packaging, stickers and accessories from the interior and exterior of the appliance.  
Remove tank A and clean it in water, taking care that no particles remain in the tank.  
Then fill the tank A with cold water and reposition it firmly on its base D making sure that the release valve  
C is properly engaged (fig. 1a, 1B and 2).  
Plug in the appliance to an electrical supply of the correct voltage.  
Place a container that holds approximately 1.5 litre under tap E  
Press the continuous water supply button H: hot water will begin to run out (fig. 3).  
When operating for the first time, it is normal that a little steam escapes from nozzle E.  
When the container is almost full, release the continuous water supply button H to stop the flow. Discard  
the water.  
1
2
3
4
5
6
7
INSTALLING THE CLARIS FILTER CARTRIDGE  
(according to models)  
• We advise you to get the best taste and service lifetime of your appliance by using the Claris - Aqua Filter  
System cartridge. This cartridge contains an anti-lime substance and activated carbon that reduces chlorine,  
impurities, lead, copper, pesticides, etc. that are present in water. Minerals and trace elements, however, are  
preserved.  
1 Unwrap cartridge J. Take note of the month in which the cartridge is put in use by sliding the upper ring of  
the filter to the use start date (fig. 4). You should change your Claris Filter Cartridge every 4 to 6 weeks  
(or every 50 litres), according to the hardness of your water.  
Certain models also have an indicator light K which indicates when it is necessary to change the cartridge.  
For these models, when this light K flashes during use, it is time to change the cartridge (fig. 5).  
2 Position the cartridge in tank A and screw the cartridge J a quarter turn into the bottom of the tank.  
3 To replace the cartridge, remove the used cartridge and fit a new Claris Aquafilter system cartridge sold as  
an accessory (Ref. XH 5000) (fig. 6).  
4 For models with an indicator light, it is necessary to record the change of the cartridge by simultaneously  
pressing the “continuous water supply” button and the mug pre-select button G for 5 seconds (fig. 7).  
After 5 seconds, the indicator light will go out. The appliance will then have recorded the cartridge change.  
• The Claris AquaFilter cartridge can be installed in all Tefal water urns, including those that did not have it  
on purchase.  
11  
 
SGETTING STARTED  
CLEANING AND MAINTENANCE  
• Place the appliance on a flat, stable, heat resistant surface away from water  
splashes and any sources of heat.  
• Systematically disconnect the power supply cord before any maintenance  
operation. Then clean the appliance with a damp cloth.  
Do not immerse the  
appliance in water  
Do not put the appliance  
in the dishwasher  
- Do not fill the tank with  
hot water, milk or any  
other liquid  
- Make sure that no  
foreign body such as  
grit or small particles  
gets into the water  
tank: any damage  
arising from foreign  
bodies having entered  
the tank is excluded  
from the guarantee.  
- Make sure that the  
water is fresh so that it  
has not had time to  
become stagnant or in  
contact with the air and  
that it is odour free  
- Never remove the tank  
while the appliance is in  
operation.  
GB  
1 – Put the appliance into the mains.  
2 After having removed the lid B, remove and fill the tank A with cold water  
(fig. 1a and b).  
3 Put the tank back in place by pressing firmly and reposition the lid B(fig. 2).  
4 Place the desired container under the nozzle E (fig. 8).  
5 Press “continuous water supply” button H and you will instantly obtain hot  
water (fig. 3).  
Keep it held down until you get the amount of hot water you want. Hot  
water will stop running as soon as you release the button.  
6 You can also use the automatic setting button with a pre-set quantity for  
mugs. In this case, briefly press button G. The appliance will instantly  
provide the quantity needed to fill a mug and stop automatically. If you  
wish, stop the water before the end of the cycle, then again press the same  
automatic button G (fig. 8).  
7 Models equipped with a quantity selector offer an additional function: you  
can adjust the amount of water automatically delivered to your container.  
To do this, select the chosen amount on the selector I, then press the auto-  
matic mug button G; the water flow will stop automatically (fig. 9).  
8 If you use small cups, we advise you to bring the cup in close to tap E to  
avoid splashing.  
What to do if there is a PROBLEM  
Problems  
Probable causes  
Corrective actions  
Fill tank  
Appliance makes a strange noise  
No more water left in tank  
Tank is incorrectly fitted  
Press the tank firmly to engage again  
Water flows too slowly or not at all  
Not enough water in tank  
Fill tank  
The tank is not fitted correctly  
Press the tank firmly to engage again  
Descale appliance  
The appliance is coated with scale  
Water is cold  
The appliance is coated with scale  
Descale appliance  
- If you use an entire  
tank of water all at once  
(approximately  
1.5 litres), let the  
appliance rest for  
Do not use the appliance.  
No attempt must be  
made to disassemble  
the appliance or safety  
devices.  
IF YOUR APPLIANCE IS DROPPED, HAS LEAKS OR IF THE POWER SUPPLY  
CORD OR PLUG ARE VISIBLY DAMAGED  
Return your appliance to your authorised Service Centre. See the warranty  
conditions and the list of centres in the handbook provided with your  
appliance.  
10 minutes before  
launching a new cycle  
The type and series number are shown on the base of your model.  
This product has been designed for domestic use only. Any commercial use,  
inappropriate use or failure to comply with the instructions, the manufacturer  
accepts no responsibility and the guarantee will not apply.  
DESCALING your appliance  
In order to optimise the lifetime of your appliance, we recommend that you descale it at least every 2 months.  
Descaling should be carried out more frequently if you live in a very hard water area.  
To de-scale:  
IMPORTANT: SAFETY INSTRUCTIONS  
• Carefully read the operating instructions before first use of the appliance and keep them in a safe place:  
Tefal shall not be held responsible for incorrect use.  
• Only connect the appliance to an earthed socket. Check that the power supply voltage shown on the  
appliance’s rating plate corresponds to that of your installation  
Take care not to place the appliance on a hot surface like a hot-plate or use it close to a naked flame.  
• Immediately take the plug out from the mains if the appliance does not function correctly.  
• Do not pull the power supply cable to remove the plug.  
• Do not let the power supply cord hang down on the edge of a table or a work surface.  
• Do not place your hand or the power supply cord on the hot parts of the appliance.  
• Never soak the appliance, the cord or electrical plug in water or other liquid.  
• Keep the appliance out of reach of children and certain disabled persons do not let the cord hang down.  
• Do not use the appliance if the power supply cord or the appliance itself are damaged.  
To avoid any danger, do not use the appliance if the power supply cord or plug are damaged. It is  
compulsory to have the power supply cord replaced by a TEFAL authorised centre.  
• Always refer to the instructions to de-scale the appliance.  
1 Remove the Claris filter cartridge (fig. 6).  
2 Place a container with at least 1.5 litre under the spout.  
3 Empty the tank A if it is is still full of water, then reposition it on its base (fig. 2).  
4 Pour 1 litre of commercially available white vinegar at 8° into the tank.  
5 Press the continuous water supply button H and the mug pre-select button G simultaneously for at least  
10 seconds (fig. 7).  
6 The descaling cycle thus run automatically for approximately 10 minutes  
7 When the cycle has come to an end, empty the container and refill the water tank to a maximum. Press the  
“continuous water supply” button H to relaunch a new operation for rinsing the appliance (fig. 3).  
8 Once the last cycle has finished, reposition the Claris cartridge and your appliance will again be ready  
(fig. 6).  
Never use any other de-scaling method than that recommended.  
12  
13  
 
• Protect the appliance against humidity and frost.  
PROTECTING THE ENVIRONMENT  
• Do not use the appliance if it does not operate correctly or if it has been damaged. In such an event,  
you are advised to have the appliance examined by a TEFAL authorised centre (see list in TEFAL Service  
handbook).  
GB  
• Except for cleaning and scale removal in accordance with the procedures for use of the appliance, any  
intervention on it must be performed by a TEFAL authorised centre.  
Let’s all help protect the environment!  
• Any error in electrical connection cancels the warranty.  
• Disconnect the appliance as soon as you have finished using it for a while or when cleaning.  
• All appliances are subject to severe quality inspection. Practical tests using appliances taken at random are  
conducted and this may explain any marks showing prior use.  
Your appliance contains valuable materials which can be recovered or recycled.  
• You are advised not to use multiple sockets and/or extension cords.  
• This appliance is not intended for use by persons (including children) with reduced physical,sensory or  
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or  
instruction concerning use of the appliance by a person responsible for their safety."  
Children should be supervised to ensure that they do not play with the appliance.  
Take it to a local civic waste collection point or an authorised service centre for it to be  
recycled.  
SAFETY LIMITS  
This hot water dispenser must only be used with water in the tank. Tefal accepts no responsibility for any  
damage resulting from the appliance being used for unauthorised purposes, faulty connections, dangerous  
manipulations, operations and repairs. The maintenance warranty will be void in such circumstances.  
This appliance is intended for domestic use inside the home only. It is not designed for commercial or  
professional use.  
PREVENTNG DOMESTIC ACCIDENTS  
Even slight burns can sometimes be serious for children.  
To avoid accidents, do  
not carry your child  
or baby when drinking  
or carrying a hot drink.  
As they grow up, teach your children to take great care with hot liquids they  
may encounter in the kitchen. Place the appliance and power cord well behind  
the work surface outside reach of children and certain disabled persons.  
If an accident occurs, immediately apply cold running water to the burn and  
call a medical doctor if necessary.  
14  
15  
 

Grundig Hair Clippers MC 4840 User Manual
Haier Drill FCD JTHMG100 E User Manual
Haier Juicer HJE 1024 User Manual
Hamilton Beach Hot Beverage Maker 40886 User Manual
Heat Glo LifeStyle Indoor Fireplace 8000TVD User Manual
Hotpoint Clothes Dryer TDL52 User Manual
Hotpoint Refrigerator HZ2022 User Manual
Husqvarna Brush Cutter 53 5RJ User Manual
IBM Computer Drive C1B 112 Brick On Sled Carrier 128 pin HPC User Manual
Impex Home Gym AX PWR7 User Manual